engine wiring LT10S

 std wiring loom taken out.

 time to identify the sensor's connector

 TPS, and below is water temp and CAS. the microtech CAS is actually a wire shielded use to prevent any distorted signal from angle sensor. but i dont have the picture.

 the microtech wiring loom are silver. after several year i realize that silver wire that being used not like a normal engine wire..it last much better coz the normal engine wires will burn internally especially at the joints. you will see change in color from copper to dark copper and sign of burn. but with microtech wiring loom i have never seen any of it.

 direct connection to the std wiring..the best way to connect is soldering method..if not u might gonna have problems later on.For the lt10 i install it with out the injector ballast. i wired it direct from input power supply.

I also use a shielded wire as an insulator, take a closer look at the injectors connector and CAS connector