parts of turbo ready to reassembled
ensure all parts cleaned including toolsfrom here we can see the turbine housing has been ported to larger area including entry port where the air circulate to prevent airflow through sharp edges..
i coated all parts with their name for references...compressor housing also has been ported to make smooth airflow in the circulating area..i had used a very special tool to do it due to very confined space to get into the area..it was my own hand...hehe..actually used a doctor scissor..becouse it can clamp up a sand paper while sanding..there also a new key way lock to put or rotate the compressor housing in other direction
this is a picture after installation of the compressor wheel...
ready to install to my engine....
No comments:
Post a Comment