DIY COP... coil on plug

 coils may be found on cherysler 4.7 or 300m coil..

 U also need a toyota's connector P/N 90980-11246. this connector comes in a set with seal and pin.

 make sure wires are compatable coz one of it is batt+ignition 12v.. the rest is signal from TR unit



 coil on plug COP

by using the original plate n cut it in square to fit the coils in..u might be careful coz the one that near to oil cap is quite close each other..u can also used 3mm aluminum plate if u want to..much more better coz the coils will seat more properly on flat aluminum plate

here how to wire it up..base on drawing..coil signal run base on negtive/grounding type onTR unit..this diagram is for std wiring ignition system and  not suitable if u are running with sequential setup.. sequential system requires  for u to run the each signal wire invidually..so only sequential needs an aftermarket TR like x4 or AEM ignition module.

lastly connect the 3 wire with the existing connector at ur engine harness.

Toyo R888 vs AO48 yokohama

 What i have here are semi slick tyres.. toyo r888 and yokohama A048..differently look side by side on P1 buddyclub rims. Both tyres are same in size 225-45-16 but been fitted to different size of rims.

 toyo r888 is on 16 x 8.5jj.....and A048 is on 16 x 7.5jj.. By having these 2 size  i'm gonna put wider tyre infront for better traction.